instal the last version for ios Dirac Live

#INSTAL THE LAST VERSION FOR IOS DIRAC LIVE MANUAL#

If it's still doing the weird thing, swap the left and right channels at the speaker leads. Check your signal-to-noise - on the Output and Levels screen, where is the meter sitting if you turn the output level all the way down?Ĥ. Connect your laptop for REEW measurement to the second input of the nanoAVR (not to a separate input of the receiver).ģ. Turn the subwoofer OFF to make sure that it's not somehow being used.Ģ. The idea was gracefully suggested by a member of an other forum wherre I have posted the same.ġ. I think that the following might of interest for every body. And, as expected the 2 curves look familiar. Doing so, in 5.1 setup, Rew reads the signal beginning in the sub and continuing in the speker as for Dirac. To achieve that for Rew, I had to change some settings in the receiver to by sure that it did not add filters to the fronts channels but to keep the bass management. So, for Rew check, I respect the same path for the sweep. Dirac measures speakers without filters but bass managed. delay, SPL and xover at 100hz then speakers. Here EQ off but bass management active i.e.

#INSTAL THE LAST VERSION FOR IOS DIRAC LIVE MANUAL#

What I wanted to point in my previous post is that I followed the NanoAvr owner manual instructions with the standard path : source to nano to receiver. Sweeps for Dirac arrives via VIDEO 1 input in Rotel but sweep from Rew went through VIDEO 3 input. I deliberatly play only one sweep with Dirac, save the project, and do the same with Rew all the reasons why left channel curves are similar but not the right one.Ībout HDMI input, there was a difference.

Yes indeed the mic was at the same place for all measurements.

Of course, the mic remains at is first position for rew measurements.ĭirac gives average 9 positions but it seems irrelevant to me for my purpose. All others settings are the same (2 channels PCM, no sub, speakers to large, no EQ in the receiver, no xover) As you know, for Dirac, the source bluray must send a video active signal and is setted to PCM With Dirac is the test signal coming from the laptop via usb cable or is it already encoded somewere in nano, I don't know. I performed a Dirac Live stereo calibration with NanoAVR-DL when I remarked that the curve of the right channel was very different in the low fr than the curves I was used to get with REW since many months now.įor REW measurements, the hdmi output from the laptop is connected to video 3 input in the receiver and I think that the test signal comes from the laptop via rew software.įor Dirac, hdmi output from nano is connected to video 1 in the receiver. I'd like to know if it is nothing or if I have a real issue. I am worried for my front right speaker or front right test signal.

Instal the last version for ios Dirac Live